EasyManua.ls Logo

Spectrasensors SS1000 - Checking the Fuses; Service Contact; Disclaimers; Warranty

Spectrasensors SS1000
83 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SS1000 Operator’s Manual
A
01-92-4 A .ver 97020-000948
Checking the Fuses
The main fuse is located on the back panel of the analyzer, as shown in Figure
B–1. An additional fuse is located on the DC to DC converter board inside the
housing, as shown in Figure B–2. If you need to replace a fuse, use only the
same type and rating of fuse as the original as listed in Table A–1.
Service Contact
If the troubleshooting solutions do not resolve the problem, contact your sales
representative. If returning the unit is required, obtain a Return Materials
Authorizatio
n (RMA) Number from your sales representative before
returning the analyzer to the factory. Your sales representative can determine
whether the analyzer can be serviced on-site or should be returned to the
factory.
Disclaimers
SpectraSensors accepts no responsibility for consequential damages arising
from the use of this equipment. Liability is limited to replacement and/or repair
of defective components.
This manual contains information protected by copyright. No part of this guide
may be photocopied or reproduced
in any form without prior written consent
from SpectraSensors.
Warranty
The manufacturer warrants the items delivered shall be free from defects
(latent and patent) in material and workmanship for a period of one year after
delivery to the Buyer. The Buyers sole and exclusive remedy under this
warranty shall be limited to repair or replacement. Defective goods must be
returned to the manufacturer and/or its distributor for valid warranty claims.
This warranty shall become inapplicable in instances where the items ha
ve
been misus
ed or otherwise subjected to negligence by the Buyer.
Notwithstanding any other provision of this contract, no other warranties,
whether statutory or arising by operation of law, expressed or implied,
including but not limited to those of merchantability or fitness for particular
Table A–1 Fuse specifications (refer to Figure B–1 or Figure B–2).
DWG Ref. Description Rating
F1 Miniature Fuse, 5 x 20 mm, Time Delay 250VAC/3.00A
F2 Miniature Fuse, 5 x 20 mm, Time Delay 250VAC/3.15A
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk

Table of Contents

Related product manuals