Installation
201-92-4 A .ver 97020-00094
–5
Connecting Electrical Power to the Analyzer
The analyzer comes equipped with a fully charged internal battery. Battery life
is approximately 12 hours under normal operating conditions. A 100
–250 VAC,
50/60 Hz battery charger is supplied with the analyzer. To recharge the battery,
plug the charger cable into the jack on the back of the analyzer under the serial
port.
Connecting the Output Signals
The serial output is supplied from the serial port located on the back of the
analyzer below the on/off switch. The analyzer can be connected to a serial port
on a computer with the factory-s
upplied external serial cable. If the receiving
computer has only a USB port available, a USB-to-serial adapter can be used.
SpectraSensors recommends RadioShack
®
P/N 26-183.
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk
To Next Page
Loading...
