SS1000 Operator’s Manual 3–1
3 - OPERATING THE ANALYZER
Powering Up the Analyzer
After setting up the analyzer and connecting the gas lines, you are ready to
power up the analyzer.
To power up the analyzer:
1. Power up the analyzer by turning on the power switch on the back
of the analyzer.
2. The analyzer goes through an initialization period counting down
from 15 while showing the firmware version, release date and
measurement type [Dual Peak (DP) or Direct Measurement (DM)] on
the bottom line.
The laser housing labels on the flanges of the sample cell warn
about exposure to laser radia
tion inside. Never open the sample
cell unless directed to do so by a service representative and the
analyzer power is turned off.
The optical head has a seal and “WARNING” sticker to prevent
inadvertent tampering with the device. Do not attempt to
compromise the seal of the optical head assembly. Doing so will
result in loss of device sensitivity and inaccurate measurement
data. Repairs can then only be performed by the factory and
are
not
covered under warranty.
See Figure B–1 or Figure B–2 for locating fuses. If you need to
replace a fuse, use only the same type and rating of fuse as the
original, as listed in Table A–1.
Initializing...
15
v2.41 08-12-09 DM
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk
To Next Page
Loading...
