SS1000 Operator’s Manual
3– 01-92-4 A .ver 97020-0009401
Pressure Unit
The Pressure Unit parameter designates the display units for the measured
absolute pressure in the cell. There are four choices: 0 for millibar, 1 for Torr,
2 for kPa, and 3 for psia.
Concentration Unit
The Concentration Unit parameter designates the display units for the
measured concentration. There are three choices: 0 for ppmv, 1 for lb/MMscf,
and 2 for dew point (calculated at the Pipeline Pressure set below and
displayed in the Temperature Unit set above). For percentage level
analyzers
, the choices are: 0
for ppmv and 1 for %.
Pipeline Pressure (if applicable)
On moisture systems, the Pipeline Pressure parameter sets the pressure for
the calculation of dew point. The value entered here will have the units
designated by the Pressure Unit parameter, which will be reflected by the
term in parentheses in the display.
<SET PARAMETER MODE>
Pressure Unit
0:mb1:Torr2:kPa3:psi
<SET PARAMETER MODE>
Concentration Unit
0
0:ppmv 1:lb 2:DP
<SET PARAMETER MODE>
Pipeline Pressure
0.00000
Enter a value (mb)
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk
To Next Page
Loading...
