Spectrasensors SS1000 - Table 3-1 Measurement and Control Parameters

Operating the Analyzer
301-92-4 A .ver 97020-00094
–7
4. When finished changing or viewing the measurement and control
parameters, press the # key followed by the 1 key to return to Mode
1 and normal operation.
Table 3–1 Measurement and control parameters.
Parameter Setting Function
teS resUrotcaF S
-99 – 99
Default = 1
Analyzer response adjustment
to match calibration standard in
the field.
S Factor Offset User Set
-999999 – 999999
Default = 0
Analyzer offset adjustment to
match calibration standard in
the field.
# Spectrum Average 1 – 240
Default = 4
Sets the number of scans aver-
aged for each measurement
sgnidaer 003 – 1etaR reggoL
Default = 4
Sets the number of measure-
ments to include in a running
average
ot ytilibapac gnikcart kaep steS2 ,1 ,0gnikcarT kaeP
off, on, or reset
DO
Alarm Setup Not applicable for SS1000
Alarm Setpoint Not applicable for SS1000
4-20 mA Alarm Action Not applicable for SS1000
4-20 mA % Test Not applicable for SS1000
4 mA Span Not applicable for SS1000
20 mA Span Not applicable for SS1000
-met rof tinu yalpsid eht steS1 ro 0tinU erutarepmeT
perature
-serp rof tinu yalpsid eht steS3 ro ,2 ,1 ,0tinU erusserP
sure
-noc rof tinu yalpsid eht steS1 ro 0tinU noitartnecnoC
centration
ot desu erusse
rp enilepip steS999999 – 0erusserP enilepiP
calcula
te dew point
Modbus Address User Set
0 – 250
Sets Modbus address for the
analyzer
teS resUedoM subdoM
0, 1, or 2
Sets type of Modbus protocol
teS resUDI rezylanA
0 – 2147483647
Customer definable value for
analyzer ID
teS resUDI elpmaS
0 – 2147483647
Customer definable value for
sample ID
teS resUDI tnenopmoC
0 – 2147483647
Customer definable value for
component (analyte) ID
UK Distibution by IMA Ltd Tel: +44 (0)1943 878877 Email: info@ima.co.uk Web: www.ima.co.uk