The aircraft must be configured and binding complete prior to testing the failsafe settings.
To test the function of the failsafe settings:
1. Power on the transmitter and receiver and confirm the controls function properly.
2. Power off the RF signal on the transmitter by double clicking the power button to
access the Sleep Mode screen.
3. Touch Advanced Options, switch off Spektrum RF and swipe the
SWIPE TO APPLY bar. The throttle and control surfaces should immediately
move to the expected failsafe positions or hold position depending on the failsafe
type set during bind. Throttle should always be set to return to low throttle.
4. Restore the RF signal by re-accessing the Sleep Mode menu as above,
switching the Spektrum RF to on, and SWIPE TO APPLY.
To Next Page
Loading...
