PHYSICAL TRANSMITTER ADJUSTMENTS
The adjustment points for the iX14+ are
located around the face of each gimbal.*
This arrangement allows for quick and
easy adjustment without removing the
back cover.
The available adjustments include:
• Mode Change
• Throttle Ratchet
• Throttle Tension
• Stick Tension
NOTICE: Always perform a stick
tension test while turning the screws to
ensure stick tension is not too loose or
too tight. Overtightening a screw can
damage the spring. Loosening a screw
too far can cause a spring to fall out in
the transmitter and possibly damage
the circuitry within.
*The gimbal adjustment screws are covered
by small rubber plugs. Carefully remove
these plugs prior to making adjustments.
The plugs are not interchangeable. Ensure to
note from where each plug is removed and
replace them accordingly.
To Next Page
Loading...
