REVERSE
Use the Reverse menu to reverse the travel direction of any channel. For example, if the
elevator moves up and it should move down, reverse the elevator channel travel direction.
To reverse a channel travel direction:
1. Select Reverse in the Servo Setup menu ribbon.
2. Touch the button next to the channel you wish to reverse.
If the throttle channel is reversed, a confirmation screen appears. Select YES
to reverse the channel. A second screen appears, reminding to re-bind the
transmitter to the receiver, at low throttle, to re-set the throttle failsafe.
CAUTION: Always rebind the transmitter and receiver after reversing the
throttle channel. Failure to do so will result in the throttle moving to full
throttle if failsafe activates.
Always perform a control test after making adjustments to confirm
the model responds properly.
To Next Page
Loading...
