To program Throttle Cut:
1. From the Model Adjust menu, touch
Throttle Cut.
2. Assign a switch to throttle cut either
by choosing the switch from the
popup menu or by using auto switch
selection. The numbered boxes give a
visual representation of which switch
position throttle cut will activate.
The shaded box indicates throttle
cut is active. These boxes can be
changed to on or off by touching them
once. The gray bar under the boxes
indicates the current position of the
active switch.
IMPORTANT: Always have at least one
switch position “on” and at least one
“off” for the throttle cut to function as
intended.
To Next Page
Loading...
