To apply changes to the video transmitter from the iX14+:
1. Power on the video transmitter and ensure it is properly connect to the aircraft
receiver.
2. From the Model Adjust menu, touch Video Tx.
3. Adjust the Band, Channel frequency, Power level and Mode to the desired values.
Pit mode sets the video transmitter output to very low power for testing in the pits.
Do not attempt to fly using pit mode.
Race mode sets the video transmitter output to normal power.
4. Press SEND to apply the changes. The video transmitter must be properly
connected and powered on to apply changes.
To Next Page
Loading...
