Two built-in sequencers are set up for different styles of gear doors.
• Door Cycle/Wheels: for P-51 style gear doors where the gear doors open first, the
retractable landing gear cycles in or out, and the door closes.
• Door Basic/Wheels: for gear door systems that require the door to stay open with the
landing gear.
These values are only meant to serve as a baseline and are defaults, but any of the
four sequences can be re-named and fully reconfigured. Two additional sequencers
are left open for any application.
The total time for the sequence is shown along the horizontal axis of the graph.
The output channel position is shown on the vertical axis. The vertical axis is scaled
from -100 to 100 based on the travel adjustment set in the servo setup menu. Each
channel has its own independent timeline.
To Next Page
Loading...
