To configure the AS3X functions:
1. Configure the receiver for remote gain using the AS3X application. In the receiver
configuration, each axis under every flight mode must be set to RELATIVE (REL)
to connect that gain value to the remote gain channel. Leaving gain settings as
ABSOLUTE (ABS) during the setup will mean the gain values are fixed and will not
be affected by the remote gain channel.
2. With the aircraft powered on and bound to the iX14+, enter the Telemetry menu
in Model Setup and select Auto-Config to set up the telemetry to work with AS3X.
3. From Model Adjust, enter the AS3X menu. This menu is scrollable by touching
and dragging up or down to show additional information.
4. If not already done in the Flight Mode menu, assign Switch to the desired switch.
5. Select the appropriate gain channel to match the assignment during the receiver
setup.
6. Select the Input switch between the L or R trim switch. This switch will make
the actual gain changes.
To Next Page
Loading...
