To adjust the Differential:
1. From the Model Adjust menu, touch
Differential.
2. Set Switch to On to use a single value
for differential, or assign a switch from the
popup menu.
3. Touch the value box to adjust the
differential value. A positive differential
value decreases the amount of down aileron travel of both ailerons. A negative
differential value decreases the amount of up aileron travel of both ailerons. A
setting of 100 eliminates down travel entirely. A setting of –100 eliminates up
travel. Selecting 50 or –50 reduces the down or up travel by half.
4. When the value is set, touch OK to save the setting.
5. Touch Inhibit next to Rate OTF to add a trim switch to adjust and refine the
differential percentage while flying.
To Next Page
Loading...
