To program an ACRO, aircraft type gyro:
1. Touch CURVE to open the custom curve mix.
2. Assign the input channel for the gyro. For example, if the gyro is installed to
assist the aileron channel, select Aileron.
3. Assign the output channel for the gyro, for example, the Gear channel. The gain
signal from the gyro must be plugged into the designated port to function properly;
in this case, the gear port.
4. Add the desired gyro gain values to the points on the curve.
5. To add more points on the curve, move the master control input to the desired
location for the new point on the curve, and touch the Add Pt button.
6. Assign the switch positions to activate the gyro curve. The curve is active when the
box is solid.
To Next Page
Loading...
