In the default state, the kickpoint for the transition between positions 0 and 1 is
at 75%. The kickpoint for the transition between positions 1 and 2 is at -75%.
The input is in switch position 1 at neutral (0%). Moving the input above 75%
will change it to position 0, and moving it below the -75% value changes it to
position 2.
Kickpoints can be assigned to any value between -100% and 100%,
allowing the kickpoints to be assigned as close to or as far apart as desired. The
values of the kickpoints determine where they trigger along the travel range. If
the values are the same, the switch output will skip position 1 and jump between
positions 0 and 2.
To Next Page
Loading...
