WARNING: Never put the RF into sleep mode when connected to a model
that is powered on. Loss of control and/or serious injury may result.
To put the transmitter or the screen in sleep mode:
1. Either double tap the Power Button or touch Sleep Mode in the Model Setup
menu.
2. Touch Advanced Options to display the sleep options.
3. Touch the OFF/ON button(s) to turn off any combination of the Spektrum RF,
Screen or Bluetooth.
4. Slide the SWIPE TO APPLY slider fully to the right to apply the changes.
An alternative method to put the transmitter fully into sleep mode is to swipe down
the SWIPE TO SLEEP ALL slider on the right side of the screen.
When both the RF and screen are in sleep mode, the LED slowly pulses for
approximately one minute to indicate the iX14+ is still powered on.
To wake the iX14+ from sleep mode, single-tap the Power Button.
To Next Page
Loading...
