INSTRUCTOR TRANSMITTER CONFIGURATION
1. Select the type of trainer mode for the application (Wired or Wireless,
Programmable Instructor or Pilot Link Instructor).
2. Choose whether or not to enable Instructor Over-Ride. This setting defines how the
instructor can resume control from the student. When enabled, the instructor must not
move the sticks when the student is given control. Moving the sticks or moving the
selected trainer switch will return control to the instructor.
With Instructor Over-Ride disabled, the switch position determines who is in control.
When Switch I or the right or left trim button is selected, Instructor Over-Ride is disabled
by default. When any other switch is selected, Instructor Over-Ride is enabled.
3. If Wireless Trainer mode was selected in step 1, Bind the student transmitter to
the instructor transmitter. See the Binding Wireless Trainer section.
4. Determine which channels to assign to the student when given control by
moving the on-screen switch for each channel. Students can be given control of
a single channel or all channels, as the instructor sees fit.
To Next Page
Loading...
