Sperry Marine VisionMaster FT - X-Band Turning Unit (for Use with Bulkhead Transceiver); S-Band Turning Unit (for Use with Bulkhead Transceiver); X-Band Bulkhead Transceiver 65810 F, 65810 L, 65825 F, 65825 L; X-Band Bulkhead Transceiver 65810 B, 65810 T, 65825 B, 65825 T

VisionMaster Ship’s Manual Chapter 11
Additional Features X-band Turning Unit (for use with
Bulkhead Transceiver)
65900011 11–33
4.3 X-band Turning Unit (for use with Bulkhead Transceiver)
4.4 S-band Turning Unit (for use with Bulkhead Transceiver)
4.5 X-band Bulkhead Transceiver 65810F, 65810L, 65825F, 65825L
4.6 X-band Bulkhead Transceiver 65810B, 65810T, 65825B,
65825T
Table 20: X-band Turning Unit (Bulkhead Transceiver) Spares
Description Spare Part Number
Input PCB T65801819
Pulse Bearing PCB T65801826
Motor Drive PCB T65801827
Table 21: X-band Turning Unit (Bulkhead Transceiver) Spares
Description Spare Part Number
Input Board T65801819
Table 22: Transceiver 65810F, 65810L, 65825F, 65825L Spares
Description Spare Part Number
Transceiver Type 65810F, 65825F 65810L, 65825L
Trigger Board
*
* T65801806 can be used to replace T65801803, but if the radar silence
input is being used with the RS422 format it will be necessary to
connect a 120 ohm resistor between TSD1 and TSD2.
T65801803 or T65801806 T65801825
Input Board T65801815 T65801815
Table 23: Transceiver 65810B, 65810T, 65825B, 65825T Spares
Description Spare Part Number
Transceiver Type 65810B, 65825B 65810T, 65825T
Trigger Board
*
* T65801806 can be used to replace T65801803, but if the radar silence
input is being used with the RS422 format it will be necessary to
connect a 120 ohm resistor between TSD1 and TSD2.
T65801803 or T65801806 T65801825
Input Board T65801821 T65801821