Hands free Operation
Hands free operation of the PCS 571/572 enables you to have a telephone conversation via the phone’s
speakers. This is done by pressing the Speaker button rather than lifting the handset. You can switch
between hands free and handset during a call as described in the Switch to Hands Free section from
page 16.
If you connect a headset to the headset port on the PCS 571/572 your hands free conversation will be via
the headset and not through the phone’s speaker. You can configure your phone so that the ringing tone
will only be heard via your headset, please refer to the Headset Ringing section from page 39 for further
details.
Your phone can be configured so that your calls can only be handled hands free, when using a headset in
most cases, and the handset will become inoperable. This may have already been configured for you.
Please refer to your System Administrator for further details.
Screen Saver Mode
Your PCS 571/572 may be configured so that the context sensitive display will dim after your phone has
been idle for a certain amount of time. If this feature has been configured on your phone as soon as you
use your PCS 571/572 again the display will return to full brightness. Your PCS 571/572 may also be
configured so that a screen saver (blank screen) will appear either at a set time (usually during the night)
or when your phone has been idle for a certain amount of time. If this feature has been configured on
your phone as soon as you use your PCS 571/572 again the display will return to normal. Please refer to
your System Administrator for further information.
To Next Page
Loading...
