Owner’s Manual
39
display “WORKOUTS ####”.
Floors
Display the total floors traveled. The console will display “FLOOR #####”.
Software revision
Display the console software revision number. The console will display “CONS
41375-###”.
Machine type
Display the machine type the console is currently configured to. The console
will display “STAIRCLIMBER” or other machine type.
Machine run time in hours since last cleared (used for maintenance)
Display the machine run time since last cleared. The console will display
“MAINT HOURS #####”. This will provide the number of hours between service
or maintenance calls. The machine run time is reset to zero in the following
Diagnostics section.
3. To exit “MACHINE STATUS”, press the [CLEAR] key.
Diagnostic Codes
Diagnostic codes are used to test various components of the machine such as the
display, keyboard, serial port, alternator, and tachometer, as well as viewing the
error log information and resetting the time between service or maintenance calls.
To run diagnostics and view diagnostic information:
1. Press [Level: UP], [6], [ENTER]. The console will display “DIAGNOSTICS”
2. Press [Level: UP] or [Level: DOWN] to scan through the choices. Select the
option you want to view by pressing [ENTER].
The diagnostic options are as follows:
Test display
To test the LCD display, press [ENTER] when the message, “DISPLAY TEST” is
displayed. The console screen alternates turning on all LCD segments and a
representative program screen. Verify that all LCD segments turn on.
Operation
To Next Page
Loading...
