Owner’s Manual
34
HEART RATE PRIORITY
Both contact HR and telemetry (e.g., Polar
®
) HR signal detection are available. The
default priority of HR input is “EITHER INPUT.”
Locked/Non-Locked HR Signal Options
The “EITHER INPUT” option means that the HR source signal is not fixed during
the workout session (if the signal is lost either input will be valid). If the “LOCKED
INPUTS” option is selected then the HR source signal is locked on the first
detected signal during the workout. To set a HR signal input, or to turn off the HR
option all together, perform the following steps:
1. On the console keypad, press [Level: UP], [3], [ENTER]. At this point the
screen will display “CUSTOMIZE”. Use the [Level: UP] key until “HR INPUTS”
appears, then press [ENTER] to select th option.
2. There are six options to handle HR input signals. Press the [Level: UP] and
[Level: DOWN] keys to scroll through the options until you find the option that
you want. Press the [ENTER] key to select that option.
The options are as follows:
LOCKED INPUTS Allows either telemetry or contact HR signals to be
detected. Once the console has detected a valid input
signal it will lock out the opposite type of signal for the
duration of the workout session. For example, if you start
out using contact HR then you are limited to using only
contact HR during your workout session, even if the signal
is lost while performing the workout, and vice-versa.
EITHER INPUT Allows either telemetry or contact HR signals to be
detected. Does not lock out a particular input signal for the
entire workout. This option will detect either input signal
during a workout session, but only one at a time, and only
until the other signal terminates.
TELEMETRY ONLY Locks out contact HR signals and will only detect telemetry
signals.
HAND ONLY Locks out telemetry signals and will only detect contact HR
signals.
Operation
To Next Page
Loading...
