Owner’s Manual
41
To review the error log and reset the service timer:
1. Press [Level: UP], [7], [ENTER]. The console will display
“MAINTENANCE LOG”.
2. Press [Level: UP] or [Level: DOWN] to scan through the choices. Select the
option you want by pressing [ENTER].
Error log
To display the machine’s error log, press [ENTER] when the message, “ERROR
LOG”, is displayed. The console will report various error messages in the
display window. The total amount of errors will be displayed in the upper right
window. Note that only the highest priority reported error will be displayed.
Errors are handled in two ways. First, as a non-fatal “WARNING” which will
display the text message but continue system operation until you press the
[CLEAR] key. The second way is a fatal “ERROR” which will stop the exercise
and return the system to an idle intensity state. The console will display the
error text and not let you restart the program unless power has been turned off
and then back on. There are 16 error entries available.
Reset service time
To reset the time between service or maintenance calls, press [ENTER] when
the message, “MAINT HOURS” is displayed. Press the [0] key, then [ENTER] to
reset..
QA ID
N/A
3. To exit “MAINTENANCE LOG”, press the [CLEAR] key.
Configuration Codes
1. Press [Level: UP], [8], [ENTER]. The console will display “CONFIGURATION”.
2. Press [Level: UP] or [Level: DOWN] to scan through the choices. Select the
option you want by pressing [ENTER].
Operation
To Next Page
Loading...
