Stakpure Omnia Tap xs basic - Page 26

26
_________________________________________________________________________________
OmniaTap xs
basic
; Version August 2023
Subject to technical changes
LED limit temperature
If the temperature limit value is set to "Off" (see 13.5.2 Setup) or if the current measured temperature
value is below the set limit value, the LED lights up green. If the limit value is exceeded, the LED lights
up red.
Withdrawal button
If the system is in the main display, you can press the withdrawal button to open the withdrawal display
(see 13.4 Volume metered water withdrawal). In all other displays, the withdrawal button only has a
function if the withdrawal button symbol is next to the respective command: .
Menu / Esc button
If you press the Menu / Esc button in the main display, you get to the menu selection (see 13.5 Menu
/ Settings). For all other displays, it takes on an ESC function, which means you can cancel an entry at
any time or return to the previous menu level.
Enter key
If you have opened a display in which you can make an entry, you can activate the entry function by
pressing the Enter key. The activation of the input function is marked by the appearance of a cursor. If
the input function is active, you can confirm the input/selection and switch to the next input field or
exit the input function by pressing the Enter key again.
Arrow key up
You can use the up-arrow key to page up through the respective menu. When the input function is
active, you can use this key to increase the value or change the selection at the current cursor position.
Arrow key down
You can scroll through the respective menu in descending order by pressing the down arrow key. If the
input function is activated, you can use this button to reduce the respective value or change the
selection at the current cursor position.