Stakpure Omnia Tap xs basic - Maintenance; Maintenance Schedule and Intervals

35
_________________________________________________________________________________
OmniaTap xs
basic
; Version August 2023
Subject to technical changes
14 Maintenance
Regular maintenance and care of the OmniaTap xs system is required to ensure consistently good
water quality. For professional and regular maintenance of the OmniaTap xs system, we recommend
concluding a maintenance contract with an authorised customer service.
If improper maintenance, care and repair work is carried out on the system, the warranty
for this system will expire. Likewise, the use of non-approved consumables and spare
parts as well as any conversion measures will void the warranty and the CE declaration of
conformity will no longer be valid.
Wear suitable protective clothing such as safety shoes, gloves or safety goggles to avoid
injuries.
Water can escape through leaks. Therefore, always make sure that the floor in the area
of the work surface is dry to avoid accidents caused by slipping.
During assembly or maintenance work, the system must be disconnected from the power
supply by pulling the mains plug, otherwise there is a risk of electric shock.
14.1 Maintenance / Care intervals
The frequency of maintenance measures essentially depends on the quality of the feed water and the
amount of water drawn off. The maintenance intervals listed in the table below are recommendations
and may be necessary earlier depending on the requirements of the ultrapure water.
Care measure
Article no.
Interval
Changing the pretreatment cartridge
1920000
7
12 months
Changing the ultrapure water cartridge
19200
1
03
12 months
Changing of the UV lamp
50003452
24 months
Changing the sterile filter capsule
19100300
12 months
Disinfectant
Disinfection kit
Disinfection agent
19200091
19200057
12 months