Stakpure Omnia Tap xs basic - Decommissioning & Dismantling; Spare Parts

38
_________________________________________________________________________________
OmniaTap xs
basic
; Version August 2023
Subject to technical changes
15 Decommissioning & Dismantling
Decommissioning and dismantling may only be carried out by authorised specialist personnel.
If the OmniaTap xs system is to be decommissioned and dismantled, proceed as follows:
- Disconnect the system from the power supply by pulling out the mains plug
- Disconnect all hoses from the system connectors.
The system is now ready for dismantling.
Water can escape through leaks. Therefore, always make sure that the floor in the area
of the work surface is dry to avoid accidents caused by slipping.
16 Spare parts
R+I Nr.
Designation
Art. no.
F5
Cap filter
31000041
FI1
Flow meter
25000070
LF1
Conductivity cell pretreatment
14180001
LF2
Conductivity cell ultrapure water
14180004
LSZ1
Leakage sensor
50002819
P1
Pressure booster
pump
2900
4500
P
2
Circulation pump
2900
6
000
UV
UV immersion tube
UV ballast
50003454
26000060
V1
Inlet solenoid valve
50003160
V2
Purge solenoid valve
50003160
V3
Pressure control valve
25200051
V4
Circulation solenoid valve
50003160
V6
Check
valve
25200050
V7
Withdrawal solenoid valve
40000118
V8
Sterile overflow
50001653
V9
Check
valve
25200050
Table power supply 48V 120W
26100016
Circuit board interfaces
26000053
Circuit board
display
26000052