9
_________________________________________________________________________________
OmniaTap xs
basic
; Version August 2023
Subject to technical changes
Danger of skin and eye injuries!
Contact with the disinfectant can lead to skin and eye irritation and/or injuries!
- Always wear appropriate protective clothing (at least gloves & goggles) when
disinfecting the OmniaTap xs system to avoid contact with the disinfectant.
- Make sure that no disinfectant can escape uncontrolled from the OmniaTap
system, check the connection hoses for correct and tight fit.
- Follow the instructions that come with the disinfectant agent or disinfection kit.
Escaping UV radiation can cause skin and eye irritation or injuries!
- Only change the UV lamp of an OmniaTap xs system when it is switched off and
the mains plug is unplugged.
- When changing the UV lamp, make sure that the lamp is correctly seated in the
UV reactor.
Danger of crushing and pinching injuries!
Incorrect handling of the OmniaTap xs system can lead to crushing and pinching
injuries!
-
When handling / transporting the system, observe the system's attachment
points, which you can find in this operating manual.
-
When handling the movable dispenser arm, pay attention to possible pinch points
in the area of the joint on the main housing. Move the arm only by holding the
dispenser handle.
The safety instructions contained in these operating instructions, the existing national accident
prevention regulations and any internal work, operating and safety regulations of the operator must
be observed.
These operating instructions must be available at the place of operation at all times.
Installation, operation and maintenance of the system may only be carried out by trained specialist
personnel.
The CE mark loses its validity in the event of structural changes or the installation of accessories not
authorised by the manufacturer. Conversion and modification of the system are only permitted after
consultation with the manufacturer. Original spare parts and accessories authorised by the
manufacturer ensure safety.
Please note that the manufacturer is exempt from any liability for damage caused by improper use or
use that is not in accordance with the intended purpose.
Protect the system from frost. The ambient temperature at the installation site should be
at least +2°C.
Only operate the system within the range of the specified feed water pressure.
Access to the mains cable and the mains plug must always be freely accessible.
A safety device to protect against contamination of the drinking water according to DIN EN 1717 must
be used for the connection of water treatment systems.
To Next Page
Loading...