Using Sensormat Pads
M200 Fall Monitor – Setup & User Guide 19
Commode
Ensure the commode is clean and dry. Place the adhesive towards the
seat ring, positioning it between the seat and the commode frame.
Test the Commode Sensormat pad before each use. See “Testing the
Sensormat Pads” on page 20.
Seatbelt
For installation instructions, see the installation guide enclosed with
the Seatbelt. A Seatbelt Extender (0707-946) may also be purchased
separately.
Test the Seatbelt before each use. See “Testing the Sensormat Pads” on page
20.
Floor Sensormat Pad
Place the pad on the floor beside the bed or chair, taking care to
position it such that the patient/resident makes contact when exiting
the bed or chair. Unlike the chair or bed pads, the floor pad alarms
when pressure is applied, instead of when the pressure is removed
from the pad.
Test the Floor Pad before each use. See “Testing the Sensormat Pads”
on page 20.
Note: Floor Pads always follow Latching behavior. See “Latching and Non-
Latching” on page 16.
To Next Page
Loading...
