Star Micronics SP2000 - Page 36

– 33 –
ENGLISH
Control Codes Hexadecimal Codes Function
TM- TM-
U200 U300
<ESC> R 1B 52 Selects international character set ⁄⁄
<ESC> U 1B 55
Selects/cancels unidirectional
⁄⁄
printing mode
<ESC> V 1B 56
Designates/cancels 90˚ character
rotation
<ESC> a 1B 61 Aligns position ⁄
<ESC> c3 1B 63 33
Selects the paper-end sensor for
⁄⁄
sending the no-paper signal
<ESC> c4 1B 63 34
Selects the paper-end sensor for
⁄⁄
stopping printing
<ESC> c5 1B 63 35
Enables/disables control panel switches ⁄⁄
<ESC> d 1B 64 Prints or feeds n lines ⁄⁄
<ESC> e 1B 65 Prints or reverse feeds n lines ⁄⁄
<ESC> i 1B 69
Full-cut command to the auto cutter ⁄
<ESC> m 1B 6D
Partial-cut command to the anto cutter ⁄
<ESC> p 1B 70 Generates specified pulse ⁄⁄
<ESC> r 1B 72 Selects print color ⁄
<ESC> t 1B 74 Selects character code table ⁄⁄
<ESC> u 1B 75 Sends peripheral status ⁄
<ESC> v 1B 76 Sends paper sensor status ⁄
<ESC> { 1B 7B Enables/disables inverted printing ⁄⁄
<GS> I 1D 49 Sends printer ID ⁄
<GS> V 1D 56 Cut command to the auto cutter ⁄
<GS> a 1D 61 Enables/disables automatic status ⁄
<GS> r 1D 72 Sends printer status ⁄
<GS> z0 1D 7A 30
Setting of on-line recovery wait time ⁄