Starline S96v2 - Page 19

To set the time zone, select the 1 item in the settings menu. Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
set the desired value. The minimum step size is 1
hour.
Setting Light and Sound Indicators for Arming and Disarming
To configure the operation of light and sound indicators when arming and disarming, select the 2
item in the settings menu. Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
set the desired value.
Description of configuration options:
for silent arming and disarming (without light and sound indicators), set the value to 0;
for quiet (only light indication) — value 1;
for full (light and sound indication) — value 2;
for using only sound indication — value 3.
Setting Siren Volume for Arming and Disarming
To set the siren volume level, select the 3 item in the settings menu. Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
,select the desired siren volume level.
0 — no sound, 10 — maximum volume level.
Setting Light and Sound Indicators in "Alarm" Mode
To configure light and sound indicators in "Alarm" mode, select the 4 item in the settings menu.
Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value.
Description of configuration options:
for hidden indication (without light and sound indicators) set the value to 0;
for quiet (only light indication) — value 1;
for full (light and sound indication) — value 2.
Setting Siren Volume in "Alarm" Mode
To set the siren volume in "Alarm" mode, select the 5 item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired siren volume level.
0 — no sound, 10 — maximum volume level.
Setting Motion Sensor Sensitivity
Current time is automatically retrieved from cellular networkand satellites data (if GPS
module is available).