EasyManua.ls Logo

Starline S96v2 - Page 20

Starline S96v2
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To adjust the motion sensor sensitivity level, select the 6 item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
Setting Tilt Sensor Sensitivity
To adjust the tilt sensor sensitivity level, select the 7 item in the settings menu. Then, using
buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
Setting Warning Shock Sensor Sensitivity
To adjust the pre-warning shock sensor sensitivity level, select the 8 item in the settings menu.
Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 1
to 30.
0 — sensor disabled, 30 — maximum sensitivity level.
The selected pre-warning shock sensor sensitivity value must be greater than the alarm shock
sensor sensitivity value.
Setting Alarm Shock Sensor Sensitivity
To adjust the alarm shock sensor sensitivity level, select the 9 item in the settings menu. Then,
using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 0 to 29.
0 — sensor disabled, 29 — maximum sensitivity level.
The selected alarm shock sensor sensitivity value must be lower than the pre-warning shock sensor
sensitivity value.
Setting Tag Loss Range
To set the range of the tag loss zone, select the 10 item in the settings menu. Then, using buttons
icon-short-2.png
Image not found or type unknown
and
icon-short-3.png
Image not found or type unknown
, set the desired value from 3 to 10.
3 — minimum range, 10 — maximum range.
The tag loss zone range should be greater than the tag detection zone range.
Setting Tag Detection Range
Ensure that the set tag loss zone range is sufficient from all sides of the vehicle.

Related product manuals