button LED and 4 beep sounds. In this case, repeat steps 5 to 8.
10. Turn off the ignition after 10 seconds to exit the registration mode.
off.png
Image not found or type unknown
11. Exiting the "Device Registration" mode will be confirmed by 2 flashes of the service button
LED and 2 beep sounds, after which there will be signals corresponding to the total
number of registered remote keys, BLE tags, and smartphones.
Deleting the owner authorization code
To delete the owner authorization code, follow these steps:
1. Set the system to "Disarmed" mode.
6.png
Image not found or type unknown
2. Turn off the ignition if it is on.
off.png
Image not found or type unknown
3. Press the service button 7 times.
press 7 times.png
Image not found or type unknown
4. Turn on the ignition. The service button LED will flash 7 times, accompanied by 7 beep
sounds.
on.png
Image not found or type unknown
5. Entering the registration mode will be confirmed by 2 flashes of the service button LED
and 2 beep sounds.
valet_2_times.png
Image not found or type unknown
6. Press the service button 3 times.
7. Wait for the long signal of the service button LED, confirming the deletion of the code
from the system memory.
8. Turn off the ignition.
off.png
Image not found or type unknown
9. Exiting the "Device Registration" mode will be confirmed by 2 flashes of the service button
LED and 2 beep sounds, after which there will be signals corresponding to the total
number of registered remote keys, BLE tags, and smartphones.
To Next Page
Loading...
