User manual
Changing the owner
authorization code (PIN-to-
Drive)
The owner authorization code is used to authenticate the user via the car's factory buttons. To
change the owner authorization code, follow these steps:
1. Set the system to "Disarmed" mode.
6.png
Image not found or type unknown
2. Turn off the ignition if it is on.
off.png
Image not found or type unknown
3. Press the service button 7 times.
press 7 times.png
Image not found or type unknown
4. Turn on the ignition. The service button LED will flash 7 times, accompanied by 7 beep
sounds.
on.png
Image not found or type unknown
5. The system will confirm entering the registration mode with 2 flashes of the service
button LED and 2 beep sounds.
valet_2_times.png
Image not found or type unknown
6. Enter the new owner authorization code using the car's built-in buttons with an interval of
no more than 3 seconds between presses. Each press will be accompanied by a single
flash of the service button LED.
press standard buttons.png
Image not found or type unknown
The owner authorization code consists of a sequence containing from 2 to 25
presses of the car's built-in buttons. Refer to the list of supported car buttons on
the can.starline.ruwebsite. If there is no flash of the service button LED after
pressing the car's built-in button, then the button is not supported in this car.
7. Two flashes of the service button LED and 2 beep sounds will confirm the acceptance of
the code 3 seconds after the completion of entering the owner's code.
valet_2_times.png
Image not found or type unknown
8. Enter the owner authorization code again.
9. If the code is entered correctly, there will be 2 flashes of the service button LED and 2
beep sounds. If the code is entered incorrectly, there will be 4 flashes of the service
To Next Page
Loading...
