Stenograph Diamante - Page 73

73
Chapter 3: Writing on the Diamante
© 2012 Stenograph, L.L.C.
5. Perform one of the following adjustments:
• More—Increase the key sensitivity when the key is not showing in the steno notes and you want
it to register. Increase the sensitivity using increments of 5. It is strongly
recommended that you
make the first incremental setting and assess the change. Turn on CNN or the equivalent and
write against the broadcast for 20 - 30 minutes.
• Less—Decrease the key sensitivity when the key is showing in the steno notes and is not
wanted. Decrease the sensitivity using increments of 5. It is strongly
recommended that you
make the first incremental setting and assess the change. Turn on CNN or the equivalent and
write against the broadcast for 20 - 30 minutes.
• Reset—Return all the key settings to the factory default.
6. When finished, press Done. You are prompted to save the settings to a profile. While writing, you are
prompted after you End the job. No prompting occurs if you selected to Reset all the key settings to
the factory default.
Keyboard Profiles
A keyboard profile is a group of Keyboard Settings saved to a file. When you load a saved Keyboard
profile, the Diamante automatically applies the saved Keyboard Settings. You can have up to ten
different profiles. See Keyboard Adjustments on page 70 and follow the steps to make changes to your
Keyboard Settings and save them to a profile.
Load a Profile
1. Do one of the following:
• Before writing, press Setup, More, Keyboard, Profiles.
• During a job, press More, Setup, Keyboard, Profiles.
2. Use the Up /Down buttons to select a profile.
3. Press Load.
4. Do one of the following:
• Before writing, press Quit twice.
• During a job, continue writing.