STIEBEL ELTRON WPF 5 basic

INSTALLATION
Commissioning
32 | WPF basic www.stiebel-eltron.com
11.5 Heat pump manager commissioning summary
(Control level 3)
No. Parameter (shown in the display)
FIRST STARTUP
1
ENTER CODE
2
LANGUAGE GERMAN --- BACK
3
CONTRAST
4
DISPLAY ACTUAL RTRN T OUTSIDE TEMP DAY DHW TEMP MIXER TEMP
5
EMERG OPERTN ON / OFF
Note
The COOLING MODE parameter must only be set if there is a suitable hydraulic circuit.
6
COOLING OP ON / OFF PASSIVE FAN AREA BACK
SET ROOM T SET ROOM T
SET FLOW TEMP SET FLOW TEMP
HYSTERESIS HYSTERESIS
COOLINGMODE
ON / OFF ACTIVE FAN AREA BACK
SET ROOM T SET ROOM T
SET FLOW TEMP SET FLOW TEMP
HYSTERESIS HYSTERESIS
DYNAMIC DYNAMIC
7
HEAT-UP PROG ON / OFF LOW END TEMP LOW END DURAT MAX HEAT-UP T MAX HUT TIME
BACK INCREASE/DAY
8
SUMMER MODE ON / OFF BUILDING TYPE OUTSIDE TEMP BACK
9
PUMP CYCLES ON / OFF
10
BU PUMP CONST ON / OFF
11
FIXED VALUE OFF / °C
12
SOURCE ETHYLENE GLYCO POTASS CARB ALM 0 ALM 30 ALM 60
WAT ER ALM 180 ALM 120
13
MIN SRCE TEMP °C
14
RETURN MAX °C
15
MAX HTG FLOW T °C
16
HP SENSOR BAR