WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
WARNING! Be just as careful when putting
the machine back on a at surface; two people
are needed for this operation.
C) Vertical positioning
WARNING! Two people will be needed for
this ope ration. When lifting and tipping back-
wards, only solid parts should be gripped (steer-
ing wheel, frame, rear plate, etc.) and NEVER
parts of the bodywork in plastic.
The tank must be checked before putting the machine
in a vertical position to make sure that there is no more
than 2 litres of fuel inside.
To assure full stability, the machine must only be rest-
ed on the points shown, inserting two blocks (1) of
about 150 mm under the lower edge of the plate and
taking care not to damage the parts in plastic and the
grass-catcher mounts (2).
WARNING! Before carrying out any type of
work make sure that the machine is completely
stable, and avoid operations that could cause it
to fall over.
CHAPTER REVISION FROM ... PAGE
2.3 0 2018 2 of 2
LIFTING AND LOWER ACCESSIBILITY
1
2
1
150 mm
1
To Next Page
Loading...
