WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
On assembly, follow the procedures described above
in reverse order.
If previously removed, reassemble the pulley (8) using
the hole (8a) available on the plate.
When assembly is completed, ...
Ret the engine pulley and the clutch.
Adjust the drive engagement.
Reassemble the wire of the deck lifting lever.
Remounting the cutting deck.
Reassemble the rear of the conveyor.
REPLACEMENT OF THE DRIVE BELT
CHAPTER REVISION FROM ... PAGE
6.4 1 2018 2 of 2
To Next Page
Loading...
