121MS 201, MS 201 C, MS 201 T, MS 201 TC
No. Part Name Part No. Application Rem.
17 Flange 5910 855 4201 Sealing exhaust port for leakage test
18 Torque wrench 5910 890 0302 0.5 to 18 Nm
19 Torque wrench 5910 890 0312 6 to 80 Nm
20 Installing tool 9 5910 890 2209 Installing hookless snap ring in piston
21 Screwdriver bit, T 20 x 100 5910 890 2301 IS screws 1)
22 Screwdriver bit, T 27 x 150 5910 890 2302 IS screws 1)
23 Screwdriver 5910 890 2306 Adjusting the carburetor
24 Screwdriver bit, T 27 x 150 5910 890 2400 IS-P screws 1)
25 Hook 5910 890 2800 Detaching springs on clutch shoes
26 Assembly stand 5910 890 3101 Holding saw for repairs
27 Punch-down tool 5910 890 4000 Fitting electrical wires in guides
28 Puller 5910 890 4400 Removing oil seals
- Jaws (No. 3.1) 0000 893 3706 Removing oil seals
29 Puller 5910 890 4502 Pull off the limiter cap.
30 Puller 5910 890 4504 Removing flywheel
31 Stud puller M8 5910 893 0501 Removing bar mounting stud
32 Socket, 13 mm 5910 893 5608 Removing flywheel nut
33 Setting disk 5910 893 6600 Add-on for screwdriver (adjusting
carburetor)
34 Hook 5910 893 8800 Removing pickup body
35 Installing tool 5910 893 9600 Removing and installing collar nut in
sprocket cover
Remarks:
1) Use for releasing only.
To Next Page
Loading...
Need help?
General
