EasyManua.ls Logo

Stihl RT 4082 - Page 118

Stihl RT 4082
183 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0478 193 9905 C - EN
116
Air holes in the grass catcher box
blocked (no air flow in grass catcher
box).
Discharge chute or mowing deck
(inside) soiled through deposited grass
residues (residue from last mowing
operation).
Remedy:
Adjust level sensor. (Ö 8.15)
Set a higher cutting height.
Wait until the lawn is dry.
Sharpen or replace the mowing blade.
(Ö 14.7)
Mow the lawn in two stages:
1. Mowing at the highest cutting level,
2. Mowing at the desired cutting height.
Clean the grass catcher box (clean air
holes).
Clean discharge chute or inside of
mowing deck.
Fault:
Level sensor (grass catcher box) does not
respond properly.
Possible cause:
Level sensor (grass catcher box) soiled
through grass residues.
Level sensor (grass catcher box)
incorrectly adjusted.
Driving speed too high.
Remedy:
Clean the level sensor and check for
ease of movement.
Adjust level sensor (grass catcher box).
(Ö 8.15)
Adapt driving speed to the mowing
conditions (reduce driving speed).
Fault:
Mowing blade does not switch on/does not
turn.
Possible cause:
The safety devices are preventing
activation of the mowing blade.
V-belt (mowing deck) worn, detached or
defective.
Remedy:
Check whether all the safety
requirements for activation of the
mowing blade are met. (Ö 11.)
Check V-belt (mowing deck) and
replace if necessary. (#)
Fault:
Engine cuts out when mowing deck
activated.
Possible cause:
User not sitting or not properly
positioned on driver's seat.
Seat switch or wiring defective.
Grass catcher box switch not actuated
or defective.
Remedy:
Sit on driver's seat or change seat
position.
Repair/replace seat switch or wiring.
(#)
Install grass catcher box or deflector
(not included in standard equipment), or
repair/replace grass catcher box switch.
(#)
Fault:
Mowing deck disengaged when mowing in
reverse driving direction.
Possible cause:
Reverse mowing safety switch not
pressed.
Remedy:
Release the mowing blades within the
time window (5 seconds before to
1 second after engaging the mowing
deck or changing the driving direction).
(Ö 8.4)
Fault:
Engine cuts out when user leaves driver's
seat.
Possible cause:
Parking brake not engaged.
Mowing deck engaged (safety device).
Remedy:
Engage the parking brake before
leaving the driver's seat. (Ö 8.10)
Disengage the mowing deck before
leaving the driver's seat. (Ö 8.3)
Fault:
Three acoustic signals sound in quick
succession.
Possible cause:
Fault in seat switch or electrics (short
circuit).
Remedy:
Turn ignition key to "engine off"
position, carry out self-diagnosis.
(Ö 9.1)

Table of Contents

Related product manuals