Still LTX 80 - Checking the battery and the condition of the battery cable

Draining and filling the drive axle
NOTE
To facilitate the flow of oil, draining should
preferably be performed when the engine is
hot.
– Park the tow tractor safely
– Switch off the ignition and remove the key
– Press the emergency stop button
– Open the battery compartment door
– Disconnect the battery connector
– Remove the cover
– Remove the oil drain plug (1) from the drive
axle gearbox. Allow the oil to drain com-
pletely into a container
– Remove the filler/level plug (2) from the
drive axle gearbox
– Refit and tighten the oil drain plug (1)
– Fill the drive axle up to the filler plug
Axle capacity: 1.2 litres
– Refit and tighten the filler/level plug (2)
– Refit the cover
– Reconnect the battery connector. Lock the
battery
– Close the battery compartment door
– Restart the tow tractor

Maintenance
5
Transmission
1411191 801 15 51 EN - 02/2021 - 10