STONEX S9III Plus - 5.2. Software Settings and Parameters

Stonex S9III Plus GNSS Receiver – User Manual 30
5.2. Settings
If you click on the command “Setting” on right, a new window is opening as in
Fig. 5.4.
Fig. 5.4 – Setting window
You can set the survey working mode Static, Dynamic --> Base/Rover (see the
red rectangle in Fig. 5.4) and below in “Datalink  Module” the kind of datalink
(NETWORK, UHF, EXTERNAL, BLUETOOTH) of S9 III PLUS.
At pagg.13-14 you can find a definition of the working mode and datalink.