STONEX S9III Plus - Network and External - Only for Base; NMEA Output String

Stonex S9III Plus GNSS Receiver – User Manual 43
5.2.3.6. Network and External - only for Base
This option give to the base the possibility to transmit the corrections through
two different data links at the same time: to an external device and to the
GSM/GPRS modem.
This case can be useful for example if the external device is an external radio,
but the customer knows that can be too far for receiving the radio signal, so
he can put a SIM card inside his rover and try a direct GSM call to the base,
this is an example but there can be others application of this functionality. In
Figure 5.20 you can see the setting for the described example: the CSD mode
is selected, the “automatically connect” function is enabled, at the same time
the baud-rate for external radio connection is set to 19,200.
Fig. 5.20 – Network and External option
5.2.4. NMEA Output string
NMEA output messages setting is available in the Setting session, as you can
see in the following figure 5.21.