Stratasys Objet1000 Plus - Safety Features

ElectricalRequirements
Thecustomerisresponsibleforensuringthatalltasksdescribedinthissectionareperformedby
qualifiedpersonnel.
Power
Astable,reliablesourceofpowerisrequired.PowertotheUPSshouldbesupplieddirectlyfromthe
mainelectricalpanel.Thepowerlineshouldnotbeconnectedtootherelectricaloutlets.
Printerinputpowerrating:
• 230VAC±2%,50–60Hz,1phase
• Fullloadcurrent:8A
• Shortcircuitrating:15A
Printershortcircuitrating:10,000A
Ifthepoweratthefacilitydoesnotsupporttheabovespecifications,contactyourStratasys
specialist.
Important:
Thediagrambelowshowstherequiredconnectiontothepowersocket.Makesure
thattheelectricianseesthisbeforeinstallingtheprinter.
Figure6Connectiondiagram
Grounding
Theprinterisgroundedthroughasingle-phase,ACplug.MakesurethattheACoutletisproperly
grounded,inaccordancewithlocalelectricalcodes.
Objet1000 Plus Electrical Requirements
13