33 STRATASYS / THE 3D PRINTING SOLUTIONS COMPANY
What: the roller waste collector collects residue of uncured and excessive resin; these residues are transferred to the
waste container through tubes and a pump.
Why: it is important to inspect the roller waste collector in order to prevent blockage of the waste tubes and leakage
on the tray.
How:
1. Remove the roller waste collector from the printer.
2. Wipe it with an isopropanol-soaked cloth until clean.
3. Inspect the roller knife.
If it’s is worn out, replace the waste collector.
4. Install the waste collector in the printer.
Clean/Replace the Roller Waste Collector
Be careful not to damage the roller knife
To Next Page
Loading...
