35 STRATASYS / FINISHING APPLICATIONS
Prepare a base solution of 2% sodium hydroxide (NaOH)
and 1% sodium Metasilicate (Na
2
SiO
3
) in a cleaning station.
Optional: Dip the printed model in a 15% glycerol solution
for 30 seconds, and then place it on a mat to dry.
This strengthens the printed model.
Cleaning Solution:
NOTE: SUP706 dissolves into the solution and eventually saturates it, reducing its effectiveness. Replace the
solution when the Support material comprises 15% of the solution, typically after several weeks of use.
To Next Page
Loading...
