Stratasys Objet24 - Safety Procedures

Safety Procedures
Hot Surface
Risk of burns from:
 Block – 70°C
 Heads - 75°C
 UV socket
Do NOT touch these surfaces while they are hot.
High Voltage
 Main Power Supply
 UV Power Supply
 UV Lamp Connectors
 X-Axis Power Supply
 Printer Computer Power Supply
Risk of Electric Shock
Ultra Violet
Radiation
Radiation from UV Lamps
Always use protective eyewear when the printer cover is open.
Manufacturer : UN process supply INC.
No : I005-017orange
Moving Parts
 4 Moving Axes - X axes, Y axes, Z axes ,T axes (wiper)
 UV Fans
 Pumps
Handling
Printing
Materials
 Printing materials (resins) are flammable – Do not expose them to flames, heat or
sparks.
 Keep resins away from food and drink.
 Uncured resin is toxic - minimize direct contact with the skin to prevent irritation
and other health hazards. Prolonged contact may cause burns.
 Always wear protective gloves.
First Aid for
Working with
Resins
 If respiratory irritation occurs, expose the victim to fresh air immediately.
 If uncured resin comes in contact with the eyes, flush immediately with large
amounts of water for 15 minutes and seek medical attention.
 When handling resins or material containers, wear protective goggles to
prevent uncured resin from splashing into the eyes.
 If uncured resin comes in contact with the skin, wash the area immediately with
soap and cool water.
General Safety
Rules
 Be familiar with the locations and use of safety equipment.
 Do not use broken equipment. Machinery with moving parts must have a working
safety interlock, and a protective cover over the moving parts.
 Do not open the cover while printer is operating.
If open, do not stare at the UV light and use protective eyewear to prevent exposure to
UV light.