Installing PDUs (Optional)
9-6 Stratus ftServer 29x0, 49x0, and 69x0 Systems: Site Planning and Installation Guide (R786)
Installing PDUs (Optional)
Power distribution units (PDUs) are an optional component.
If you have not ordered PDUs from Stratus, skip this section and continue to
“Installing a System Chassis” on page 9-11.
If you have ordered PDUs from Stratus and want to install them at this time, see:
– “PDU Components”
– “Installing PDUs in a Cabinet”
To connect the PDUs to AC power, see “Connecting Systems to Power Through PDUs”
on page 11-6.
PDU Components
The PDUs are ordered and shipped in pairs. Each PDU is shipped with mounting
brackets attached.
Verify that you have the components shown in Figure 9-4 for your PDU, and inspect
the components to ensure that they are not damaged. If you notice damage, contact
the Stratus Customer Assistance Center (CAC) or your authorized Stratus service
representative.
To Next Page
Loading...
