Safety
V 152 10 11 Rev.: END
2-2
● The bullet point indicates work and/or operating steps. The steps must be
performed in the sequence from top to bottom.
– The dash indicates enumerations.
Information and symbols, such as warning signs, actuation signs, component labels,
etc. attached directly to the gantry press must be observed. They must not be
removed and they must always be fully legible!
2.3
Intended use
The vertical gantry presses PP 1207, PP 1208, PP 1208 L and Plus 70 are to be used
solely for compressing cardboard paperboard containers, cardboard, plastic film, tin,
textiles, carpeting, plastics, as well as any materials listed additionally in the
agreement.
Strongly expanding materials such as foil or foam filled with air may only be
compressed after consultation with Strautmann Umwelttechnik GmbH.
The following may not be compressed:
– Hard paper core
– potentially explosive material and fluids, all potentially explosive materials and
containers with such content.
Information!
Note the specifications in the Technical Data and always observe them.
Intended use also includes observance of the instructions
– on safety,
– on operation and control,
– on servicing and maintenance,
which are described in these operating instructions.
Any other or further-reaching use is not regarded as intended. The plant operator of
the gantry press alone is liable for any resulting damage.
2.4
Residual risk
Even when all safety instructions are followed, there is a residual risk during operation
of the gantry press as described below.
To Next Page
Loading...
