Operation and control
V 152 10 11 Rev.: END
5-12
● Turn the locking wheel in the given
direction.
● Open the press chamber door.
or:
● Open the press chamber door using
the two-handed control (with
hydraulic door lock).
Information!
Open the press chamber door
more than 100° for subsequent
bale removal
Fig. 5-11: Open press chamber door
Tying up the bale:
● Loosen the tapes from the spring plates on the front of the door.
● Pull the tape pull hook out of the tape channel.
● Cut the binding thread to a length of approx. 1.4 m.
● Hook the tape pull hook onto the holder above the gantry press.
● For tying up, pull the two tapes until they are taut and tie a knot in the ends of the
thread.
Information!
Make absolutely sure that you cut through both ends of the thread
5.4.4
Removing bale, finishing work
● Place a euro pallet in front of the gantry press
● Use the two-handed control Manual mode button and the Raise shield button to
move the shield upwards. Press the two buttons at the same time (within 0.5
seconds).
● Keep pressing the buttons until the completed bale has been discharged onto the
pallet.
To Next Page
Loading...
