Product description
V 152 10 11 Rev.: END
3-1
3
Product description
3.1
General information
1: Press cylinder
2: Loading flap guide
3: Loading flap
4: Press chamber
door
5: Door locking wheel
6: Hydraulics cover
7: Control panel
8: Belt pulleys
9: Square tube guide
Fig. 3-1: Overview
Loading of the press chamber of the gantry press is segregated. Once compressed,
blank holders prevent any expansion and compression of the material (Circle
System). Upon reaching the set bale height (cam) in the press chamber, the pressing
shield moves up again or it is left positioned (only with foil programme) on the
compressed bale at max. pressure and the message BALE FINISHED is displayed
(See Chapter 5.2).
The pressing shield can then only be moved up when the door is open using the two-
handed control mode. The operator stands at the left next to the opened press
chamber door (4). The completed bale will be discharged onto a euro-pallet provided
via two-hand operation.
To Next Page
Loading...
