Safety
V 152 10 11 Rev.: END
2-6
Clearly specify and observe the responsibilities for the various activities connected
with maintenance and servicing. This is the only way of avoiding mistakes, in
particular, in hazardous situations.
The plant operator shall ensure that the operating and maintenance personnel wear
personal protective equipment. This shall include, in particular, safety shoes, goggles,
gloves and, if required, hearing protection.
Do not wear loose long hair, loose clothing or jewellery! There is a danger of
becoming caught, being pulled in or dragged by moving parts!
If safety-related changes are made to the gantry press, immediately shut down and
secure the machine and notify the relevant location/person of the process!
When maintaining the gantry press, follow the instructions for maintenance work!
Work on the gantry press may be performed by reliable, trained personnel only.
Observe the statutory permitted minimum age!
Personnel who are training, learning, being instructed or receiving a general
education may only operate the gantry press under the constant supervision of an
experienced person!
2.9
Safety instructions for servicing and troubleshooting on the
gantry press
Observe the stipulated periods or the periods indicated in the operating instructions
for recurring checks/inspections.
When servicing the machine, it is essential to have suitable workshop equipment for
the specified work.
Set up, maintenance and repair work, as well as troubleshooting, may only be
performed when the gantry press is switched off.
Secure an appropriately large zone around the maintenance area!
Cordon off the work area with a red and white safety chain and a warning sign!
Also attach a warning sign.
When performing maintenance and repair work, always tighten loosened screwed
connections! If stipulated, tighten the designated bolts using a torque wrench.
In particular, remove dirt or care products from connections and screwed connections
at the start of maintenance/ repairs/care.
To Next Page
Loading...
